Troubleshooting

If you select "Enable", and want to use your own e-mail server:

1 Co

nfigure the following:

• SS

L: Select ON/OFF to enable/disable Secure Socket Layer protocol

• SMTP Port: Enter your SMTP port.

• SMTP Server: Enter your SMTP Server.

• Sender: Enter the sender e-mail address. This can be any address of your choice.

• Password: Enter your e-mail server’s password.

• Receiver: Enter the recipient’s e-mail address.

• Interval: Enter the interval the DVR waits before sending a new e-mail notification. For

example, if you select a 3 minute interval, the DVR will send out e-mail notifications every 3

minutes until the DVR stops detecting motion/alarm. The DVR will only send out notifications

when it detects motion/alarm triggers.

2 Cl

ick Apply to save your settings.

Q: How do I enable and configure sequence mode?

A: In sequence (SEQ) mode, the display automatically switches between a full-screen view

of each of your cameras every few seconds.

To enable Sequence mode:

• Right-click and select Start SEQ.

To disable Sequence mode:

• Right-click and select Stop S

EQ.

To change the time each channel will display in sequence mode (Sequence Dwell Time):

1 Right-click and

select Main Menu.

2 Cl

ick Advance; then click A/V Setup. The Audio Video Setup window appears.

4/8 Channel

16 Channel

3 Under SEQ Dwell Time (4 or 8 channel) or SEQ Time (16 channel), enter the number of

seconds you would like each camera to display for before switching.

4 Cl

ick Apply to save your changes. Then, click right-click until you have exited all menus.