User Guide

a. Fit the o-ring around the camera Ethernet connector.
b. Feed the Ethernet extension cable through the end cap and the barrel then connect the cable
to the camera Ethernet connector.
c. Twist the barrel securely onto the camera Ethernet connector. The o-ring becomes
compressed when the seal is properly tight.
d. Split the stopper to wrap it around the cable between the barrel and end cap as shown above.
e. Push the stopper toward the barrel until it is underneath the teeth at the end of the barrel.
f. Twist the end cap clockwise to secure it onto the barrel. The stopper becomes compressed
and will stick out of the end cap slightly when the seal is properly tight.
Figure 6
Step ve.
1. Connect the connection cables.
Camera Ethernet connector
O-ring
Stopper
Barrel
End cap
To connect the cables using the waterproof connector (see Figure 6):