User's Manual

39
Using the Main Menu
Setting up Email Notification
The system can send email notifications
when it detects motion.
To set up email notification:
1 Cl
ick the Email tab in the Network menu.
2 F
rom the Email drop-down menu, select
from:
• Default: Uses
the Lorex email server to
send out alarm notifications. This is the
recommended selection.
• Ena
ble: Uses custom email server
settings.
• Di
sable: Disables email notification.
If you want to use Lorex’s ema
il server
(recommended):
1 In the Email dr
op-down menu, select
Default.
2 In the Se
nder Email field, enter the email
address of the sender. This can be any
email address of your choice.
3 In the Rec
eiver Email field, enter the
email address you want the DVR to send
alarm notifications to.
4 In the Interv
al drop-down menu, enter the
Duration the DVR must wait before
sending out a new notification. 

For example, if you select a 3 minute
int
erval, the DVR will send out email
notifications every 3 minutes until the DVR
stops detecting motion. The DVR will only
send out notifications when it detects
motion triggers.
5 Click Appl
y to save your settings.
If you select "Enable", and want to use
y
our own email server:
1 Configur
e the following:
• SS
L: Select ON/OFF to enable/disable
Secure Socket Layer protocol.
• SMTP P
ort: Enter your SMTP address.
• SMTP Serv
er: Enter your SMTP Server.
• Sender Email: Ent
er the sender email
address. This can be any address of your
choice.
• Sender Passw
ord: Enter your email
server’s password.
• Rec
eiver Email: Enter the recipient’s
email address.
• Interv
al: Enter the interval the DVR waits
before sending a new email notification.
2 Click Appl
y to save your settings.
Changing the Mobile Connectivity
Port, User Name, and Password
To connect to your DVR using a mobile
device, you must complete the entire
remote setup process described in
“Setting up your DVR for Remote
Connectivity” on page 47.
Use the steps below to change your
Mobile Port
or the user name and
password used to connect with a mobile
device.
Select Default