Owner's Manual

Remote Viewing

4 Click Save to apply your settings.

Configuring Alarm Notifications

To configure alarm notifications:

1 Click the Remote Setting tab>Alarm >Alarm.

2 Configure the following:

• Alarm In: Select

the channel that you wish to configure.

• Alarm Type:Select the alarm type (N/O (normally open) or N/C (normally closed)).

• Buzzer: Select the "beep" duration when an event occurs.

• Latch Time: Select the desired latch time when an alarm triggers.

• Show Message: Select the checkbox so that the system displays a warning message during

an alarm recording.

• Send email: Select the checkbox for the system to send out email alerts during an alarm

recording.

• Full Screen: Select the checkbox to enable the system to go into full screen mode when an

alarm triggers.

• Alarm out: Select the checkbox to enable alarm out devices to activate.

• Enable Record: Select the checkbox to enable system recording when an alarm triggers.

• Post Recording: Select the desired post recording time, after an alarm triggers.

• Record Channel: Select the channels that the system should record during an alarm trigger.

3 Cl

ick Sav

e to apply your settings.