Owner's Manual

30
Configuring Sequence Time
Sequence time refers to the time a
channel remains on screen before
changing to a different channel. For
example, when sequence view is
enabled, channel 1 displays on screen
for several seconds, then channel 2 etc.
To configure the sequence time:
1 Click the Output tab
.
2 Beside "SEQ Dwell time", ent
er the dwell
time (the time the channel remains
on-screen before changing to another
channel).
3 Click A
pply to save your settings.
Changing the output resolution
To change the VGA output resolution:
1 Click the drop-down menu beside "VGA
Resolution". Sel
ect the desired output
resolution.
NOTE: If you select a resolution that is
gr
eater than what your VGA
monitor supports, you may have
to reset your DVR’s resolution to
factory defaults. To do so, simply
press and hold the Stop button
on the front panel of the system
until the system restarts. Your
system resolution will default to
1024 x 768.
2 Cl
ick A
pply to save your settings.
Adjusting Transparency
To adjust the interface transparency:
1 Drag the Transparency slider to the
desir
ed settings.
2 Click Apply
to save your settings.
Adjusting the video margin
If you connect your DVR to a BNC
monitor, you can adjust the video
margins.
To adjust the video margin:
1 Click the Marg
in button.
2 Drag the sliders to the left or right to
adjus
t the following: Left Margin, Top
Margin, or Bottom Margin.
3 Click Apply
to save your settings.
Output tab