Owner's Manual

19
Recording
Recording
By default, the system is set to immediately record video from connected cameras in
Continuous Recording Mode.
• Recording—Continuous: Normal, continuous r
ecording
You can set the system to stop recording once the hard drive is full, or to continually record
by overwriting previously
recorded data. For more details, see “Configuring Hard Drive
settings” on page 43.
Event Recording
The system also includes motion recording:
• Record
ing—Motion: The system records when motion is detected by the camera
Recording Audio
The system can also record audio for up to 4 channels.
To enable audio recording:
1 Connect the BNC video cable from the camera
t
o one of the BNC ports on the rear panel of the
system. For example, connect the camera to
BNC port 1.
2 Connect the RCA audio cable from the camera
t
o the corresponding audio channel. Following
the example in step 1, you would connect the
cable to audio port 1 (AIN1).
C
.
M
ATTENTION: Audio capable cameras (not included) or self-powered microphones
are required in order to record audio on the system.
Connect an RCA audio cable into the "AIN"
(Audio In) ports.