Owner's Manual

Starting the System

Restoring the system’s resolution if you see a blank screen

If you see a blank screen on your monitor after turning on your system, the DVR’s output

resolution may be higher than what your monitor supports. Follow the steps below to

restore the DVR’s default resolution to 1024 x 768.

Prerequisite:

• Ensure video and power connections to the monitor and DVR are properly connected.

To restore the DVR’s default resolution:

1 Whil

e the system is on, press and hold the Stop button ( ) on

the system’s front panel until

the system restarts (approximately 12 seconds). The system restarts with a default resolution 

of 1024 x 768.

NOTE: If your system resolution is already in 1024 x 768, pressing and holding the Stop

but

ton will not restart the system.

Adjusting the DVR’s Output Resolution

For details on configuring the DVR’s output resolution, see “Changing the output

resolution” on page 30.

NOTE: When

adjus

ting the DVR’s output resolution, ensure your monitor supports the

selected resolution. If you select an output resolution greater than what your monitor

supports, you may have to restart the DVR using the steps above.

Stop button ( )

16 channel model shown