Owner's Manual
116
Appendix L: Replacing the Hard Drive
Appendix L: Replacing the Hard Drive
The system comes with a pre-installed 3.5" SATA hard drive. You can expand the system
with a replacement single hard drive up to 2 terabyte (TB).
NOTE: Make sure that the system is OFF and the power cable has been disconnected before
ch
anging the hard drive.
Removing the Hard Drive
To remove the hard drive:
1 Remove the screws from the side panel (x2) and rear panel (x4) of the cover.
2 Gently slide the cover away from the rear panel and lift off. Be careful of sharp edges.
3 Disconnect the power and data cables.
4 Remove the screws from the mounting brackets.
5 Gently remove the hard drive from the housing.