Owner's Manual

Using the PC/Mac Client Software

To configure PTZ settings:

1 Cl

ick the Remote Setting tab, and click Device>PTZ.

2 Co

nfigure the following:

• Channel: Sel

ect the channel that the PTZ camera connects to.

• Pr

otocol: Select the protocol of the PTZ camera*.

• Baud Rate: Sel

ect the baud rate of the PTZ camera*.

• Data B

it: Select the data bit rate of the PTZ camera*.

• Stop Bit: Sel

ect the stop bit rate of the PTZ camera*.

• Pa

rity: Select the parity settings of the PTZ camera*.

• Cr

uise: Select Enable or Disable*.

• Addr

ess: Select the address of the PTZ camera*.

*Consult the PTZ camera’s instruction manual for protocol and configuration details

3 Cl

ick Save to apply your settings.

Configuring the System Time and Date

To configure the system time and date:

1 Cl

ick the Remote Setting tab, and click System>General.

2 Co

nfigure the system format and time:

• Sys

tem Time: Enter the desired system time and date. An on-screen calendar appears when

you click the date.

• Date

Format: Select the desired format the date is displayed in.