Owner's Manual

39
Using the Main Menu
3 When the DVR restarts, click Yes to
confirm the default resolution.
NOTE: If y
our system resolution is already
in 1024 x 768, pressing and holding
the Stop button will not restart the
system.
Adjusting Menu Transparency
You can increase or decrease the
transparency of the on-screen menus.
To adjust the transparency of
on-screen menus:
1 Cl
ick the Output tab.
2 Dr
ag the Transparency slider to adjust
transparency.
3 Cl
ick Apply to save your settings.
Adjusting the Video Margin
If you connect your DVR to a BNC
monitor, you can adjust the video
margins.
NOTE: Y
ou must select the BNC output
mode to adjust the margins. Press 0
three times on the remote control to
switch the output mode between
BNC mode and VGA/HDMI mode.
When BNC mode is selected, the
mouse cursor appears on the BNC
monitor.
To adjust the video margin:
1 Cl
ick the Output tab.
2 Cl
ick the Margin button.
3 Dr
ag the sliders to the left or right to
adjust the Left, Right, Top, or Bottom
Margin.
4 Click Appl
y to save your settings and click
OK to confirm.
Adding Privacy Zones
A privacy zone allows you to block out
up to 4 portions of each channel with a
black square.
To configure a privacy zone:
1 Click the Privacy Zone tab
.
2 In the Channel
drop-down menu, select
the channel you wish to configure.
3 Configur
e the following:
• Channel:
Select the channel you wish to
configure.
• Priv
acy Zone: Select ON to enable privacy
zones or OFF to disable privacy zones.
• Ar
ea Setup: Select the Area1~4
checkboxes to enable up to 4 privacy
zones.
ATTENTION: Areas covered by privacy
zones are not visible in recordings.
Privacy Zone