User Guide
• Read this guide carefully and keep it for future reference.
• Follow all instructions for safe use and handling of the product.
• Use the camera within given temperature, humidity and voltage levels noted in the camera’s
specications.
• Do not disassemble the camera.
• Do not point the camera directly at the sun or a source of intense light.
• Periodic cleaning may be required. Use a damp cloth only. Do not use any harsh, chemical-based
cleaners.
Refer to the battery’s insert “Safety Rules for Lorex Rechargeable Batteries”.
• This camera includes an Auto Mechanical IR Cut Filter. When the camera changes between Day/Night
viewing modes, an audible clicking noise may be heard from the camera. This clicking is normal, and
indicates that the camera lter is working.
• Audio recording without consent is illegal in certain jurisdictions. Lorex Corporation assumes no liability
for use of its products that does not conform with local laws.
Battery safety precautions:
Disclaimers:
Camera safety precautions:
4. The Lorex Home Hub is oine.
• See section 3 “Status Indicator” for more details.
• Check that the power adapter is securely connected.
• Make sure the ethernet cable is properly connected to the Lorex Home Hub and your router (wired
connection only).
• Try to connect to the Internet from another device that is connected directly to your router to make
sure you are getting service.
• Power cycle the Lorex Home Hub.
• Reset the Lorex Home Hub if necessary. This will not affect recordings stored on the device.
5. Failed to pair the camera to the Lorex Home Hub.
• Ensure that both the Lorex Home Hub and camera are in pairing mode. Refer to section 3 “Status
Indicator”.
• The distance between the camera and the Lorex Home Hub is too far. Make sure the
camera is no more than 3ft from the hub during the set up process.
• Make sure you are only pairing one camera to the Lorex Home Hub at a time.
• Reset the camera. Press and hold down on the reset button until you hear the chime then try pairing
again.
• Make sure that the Lorex Home Hub has been added to the app before pairing.
6. The camera is not picking up motion detection and has a strong reection when recording through
glass.
The camera’s motion sensor will not work when recording through glass or any other building material.
The camera needs to be located outside when trying to monitor motion outdoors.
7. How to reset the camera to factory settings.
Press and hold down on the reset button until you hear the chime.