Installation Instructions

This device complies with Part 15 of the FCC Rules. Operaon is subject to the
following two condions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operaon.
Cauon: The user that changes or modicaons not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
The statement for this device will be marked with “√”
(a) This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protecon against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instrucon manual, may cause harmful interference to radio communicaons.
Operaon of this equipment in a residenal area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
(b) This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon against harmful interference in a
residenal installaon. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instrucons,
may cause harmful interference to radio communicaons. However, there is
no guarantee that interference will not occur in a parcular installaon. If this
equipment does cause harmful interference to radio or television recepon, which
can be determined by turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
√
For full FCC compliance declaraons, visit
hps://www.lorextechnology.com/FCC-compliance
LNW16XF_FCC_IC_R3.indd 2 1/18/2019 11:36:16 AM