Portable Color LCD Digital Wireless Monitoring System Quick Start Guide

ManualsBrandsLOREX Technology ManualsSecurity CameraLW2002 Series

www.lorexcctv.com

LW2002 Series Quick Start Guide_R2 Page 2

Digital Wireless Analog Wireless

 2.4 GHz Digital 2.4 GHz Analog

 Secure privacy ensured Non Secure, no privacy

 Interference FREE

Interference from

 Range up to 450 ft line of sight Up to 300 ft line of sight

 Pairing - hand shake between camera and receiver No Pairing - ﬁxed channel allocation

 FHSS - Frequency Hopping Spread Spectrum Technology N/A

 Signal strength Indicator N/A

NOTE: Decide whether the camera will be permanently

wall mounted or placed on a tabletop:

• If you decide to permanently mount the camera to a wall,

make sure to select a location close to a power outlet.

Did you know?

Power camera using the batteries:

1. Remove the Battery Cover off the base of the Camera.

2. Insert 4 x AA Batteries (*not included) into the Battery compartment.

Make sure to correctly line up the Positive (+) and Negative (-)

terminals of the batteries.

3. Place the Battery compartment cover back on.

You can use ‘AA’ batteries* to make the camera truly wireless for short periods of time.

C. Power ON Camera and Receiver

About Digital Wireless

It’s all on the Web

For detailed setup information,

please refer to your User’s Manual.

For additional information, please

visit our website

www.lorexcctv.com/support

PORTABLE COLOR LCD DIGITAL WIRELESS

MONITORING SYSTEM

LW2002 SERIES - QUICK START GUIDE

WiFi

Bluetooth

Microwave

Cordless Phone

DIGITAL WIRELESS

The table above shows that Digital Wireless Technology offers many advantages over Analog wireless. When comparing a

Digital Wireless solution to a wired solution, it is important to be aware of the bandwidth limitations. Due to bandwidth con-

straints and depending on the signal strength the frame rate, which is measured in FPS (Frames per Second) may be reduced.

For example, a Digital Wireless camera in the highest resolution (VGA 640x480) will feature a lower frame rate compared to a

wired solution which provides 30 FPS.

WiFi

Bluetooth

MicrowaveCordless Phone

ANALOG WIRELESS

NOTE: It is recommended to remove the batteries from the camera when not in use. If the Camera is plugged in with the

AC Adaptor, the batteries will not be used. The batteries are intended for short term, portable Camera use only.

As our product is subject to continuous improvement, Lorex Technology & subsidiaries reserve the right to modify product design, specifications & prices

without notice and without incurring any obligation. E&OE

1 2 3

Move the “ON/OFF” switch upwards

(located at the side of the camera)

to turn on the camera. The Green

power indicator LED will turn on.

Press the “POWER” button located on the left

side of the receiver to turn on the receiver.

You will see a Green LED turn on above

the LCD screen and Blue LEDs around the

navigation dial will ﬂash twice.

NOTE: Keep the receiver away from the camera to prevent

audio feedback (up to 10ft if volume is set to maximum).

Remember this when you are carrying around the receiver.