- Lorex Technology LCD Monitor Instruction Manual

54
Advanced Recording
Advanced Recording
Alarm Setup Mode
The Alarm Setup section controls the
Recording settings for each camera
individually (quality, resolution, frame rate
and audio). Recording Settings for external
alarm detection are set in this menu.
• PARAMETER MODE - Contains the
general recording parameters for each
camera.
• SCHEDULE MODE - Contains the
schedule recording settings for each
camera.
Alarm Parameter
Parameters for each camera are set by hour
using the Time Interval bar. Hours can be
selected individually or in groups (by clicking
and dragging several blocks).
NOTE: If Schedule Mode was set to Weekly
earlier, a day selection option is available.
Alarm Parameter
Select an Hour (highlighted in ORANGE),
and press ENTER again to open the
Camera Settings for the selected hour, or
select multiple blocks in a row and press
ENTER.
Once a time block or several blocks have
been selected, the Channel Setup window is
displayed.
• Size - Sets the video capture size for
each camera to 352x240, 704x240 or
704x480.
• FPS - Sets the Frames Per Second for
recording for each channel. Each
channel can be set to 1, 2, 3, 7, 15 or
30 Frames per second (real time video
capture) from a shared pool of 240 FPS.
If the FPS drops below 0, the settings
will not be saved.
• Quality - Sets the video recording quality
to Low, Standard, High or Highest.
• Audio - Turns audio recording ON/OFF
for 4 channels ONLY.
Once settings have been adjusted for the
hour, the changed time block will be
displayed in a different color on the Time
Interval bar.
NOTE: Each different configuration will be
displayed as a different color on the bar.
Selected Block of Hours