- Lorex Technology LCD Monitor Instruction Manual

114

Connecting Motion / Alarm Device - Appendix #13

Motion detection and Alarm controls are enabled through the Menu system on the System.

Additional motion sensor devices can be connected to the system (Motion Sensors, Door/

Window Sensors).

A motion detection or sensor unit can be used to send a signal to the System to begin camera

viewing on the matching Video Channel (when enabled in the Menu).

• Example: A Window sensor unit has been installed on Alarm Block port #4. When this sensor

is activated, the camera on DIN or BNC VIDEO port #4 will become active (if enabled in the

MENU on the System)

Installing a Sensor

1. Connect the GROUND Cable to the GND port on the Alarm Block on the System

2. Connect the SIGNAL Cable to a numbered port (1-8)

To start ALARM RECORDING on the System, configure the System Menu.

SENSOR

(Not Included)

SYSTEM

1-4 / 5-8: Alarm input terminals

receive a signal from a device (i.e.

Door or Window Sensor).

Ground

NO / NC: Alarm Output Terminals

send a signal to another device

when an alarm input is detected.