Quick Start Guide

ManualsBrandsLorex Technology ManualsElectronicsMotion Sensor

Table Of Contents

Motion Sensor

AM41TK-Z

Quick Start Guide

lorex.com

PIR Sensor

Bracket

(optional)

Mounting Adhesive

Pin*

Package Contents

AM41TK_QSG_EN_R1

LED Behavior

See the table below for denitions of the

sensor’s LED behaviors:

Lorex products come with a standard 1-year

warranty. For more information about Lorex’s

warranty policy, visit lorex.com/warranty.

WARNING:

CHOKING HAZARD

KEEP OUT OF REACH OF CHILDREN

Behavior Meaning

(solid for 2 seconds)

Powered on.

(ashing rapidly)

Ready to pair.

(solid for 2 seconds)

Pairing successful.

(ashing 3 times)

Pairing failed. Try

repeating the setup.

(ashing rapidly)

Alarm has been

triggered.

(ashing)

Firmware upgrade in

progress.

Battery slot

LED indicator

Pin insert

PIR sensor

Overview

• Environment: Indoor

•

Maximum detection distance: 26 feet

• Maximum detection angle: 110°

• Operating temperature: 14°F~113°F

• Operating humidity: 0-95%RH

• Battery: CR2450

• Protocol: Bluetooth 5.0

Specifications

*May include one or more, depending on the package purchased.

To purchase additional sensors, visit lorex.com and/or authorized resellers.

AM41TK_QSG_EN_R1.indd 1

2020-05-04 5:03:36 PM

Summary of content (4 pages)

PAGE 1
LED Behavior Package Contents See the table below for definitions of the sensor’s LED behaviors: Motion Sensor Behavior PIR Sensor Bracket (optional) Mounting Adhesive Pin* *May include one or more, depending on the package purchased. To purchase additional sensors, visit lorex.com and/or authorized resellers. Overview AM41TK-Z Battery slot Quick Start Guide lorex.
PAGE 2
STEP 1: Pairing to Your Device Changing the Battery To connect the sensor to your device: 1. Tap the Lorex Home icon to launch the app. 2. In the Devices tab, press + Add sensor to set up the sensor. NOTE: the screen to the left is taken from the Sensor Hub. 3. Follow the on screen prompts to complete the rest of the setup. The Lorex Home app will walk you through the process, step by step. Tap the + icon on the top right of the screen to add more sensors. To change the sensor’s battery: 1.
PAGE 3
IC Statement This device complies with Industry Canada licence-exempt RSS standard(s). 1. 2. This device may not cause interference, and This device must accept any interference, including interference that may Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux suivantes : 1. L’appareil ne doit pas produire de brouillage, et 2. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body. le radiateur et votre corps.
PAGE 4
FCC Statement 1. 2. This device may not cause harmful interference, and This device must accept any interference received, including interference responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are try to correct the interference by one or more of the following measures: • • • Reorient or relocate the receiving antenna.