Operation Manual

94
User Manual
Alarm is switched Off by default after a Master Reset. Once the Grounding Alarm has been
activated, a warning message is shown.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM" + 'ENTER'
Note
The Grounding Alarm function only operates with the new C-CARDs. It also affects the speed of the redraw of
the screen. If this function is not used it maybe disabled.
5.5.7 GROUNDING ALARM RANGE
Allows setting the length of the sector to be detected among 0.25, 0.5, 1.0 Nm. The
default setting is 0.5 Nm. When any of the searched objects is found in the scanned area, a
tick marker is printed on the relative box in the Grounding Alarm Report page (see Par.
5.5.9) to identify which dangerous objects have been currently detected.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM RANGE" + 'ENTER'
5.5.8 GROUNDING ALARM WIDTH
Allows setting the length of the sector to be detected among Thin, Medium and
Large. The default setting is Large.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM WIDTH" + 'ENTER'
5.5.9 GROUNDING ALARM REPORT
Allows displaying the report of the dangerous objects currently detected.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM REPORT" + 'ENTER'
5.6 SIMULATION
The built-in Simulator function allows you to become proficient in the use of the
chart plotter. No current position fix is required because the chart plotter simulates position
data internally.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "SIMULATION" + 'ENTER'
5.6.1 ACTIVATE SIMULATION
Once the settings are selected, turn on the Simulator: