Operation Manual

User Manual

4.3.5 INSERTING THE A-B-C-D POINTS

Placing cursor on the segment connecting two points, the information window

appears. Select "INSERT" and press 'ENTER': by the cursor key move the cursor, on the

screen a dotted line appears. By pressing 'ENTER' the new point is placing between the two

existed points which are renamed.

4.3.6 NAVIGATING ON THE A-B-C-D POINTS

If fix received is good, place the cursor on the desired point A, B, C or D and press

'GO-TO'. When ship reaches the Destination point, navigation follows the next point (if

exists). When Target is set, three options are available: STOP NAV, NEXT and PREV.

4.4 USING THE TRACK FUNCTIONS

As long as the chart plotter is connected to a positioning instrument, it stores all

points in its memory. The chart plotter can store a fix when the distance from its last stored

position is greater than a defined distance or after a defined time. A line connects such

points and represents the past course, called the track of the ship.

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "TRACK" + 'ENTER'

4.4.1 SELECTING ACTIVE TRACK

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "TRACK" + 'ENTER' +

"ACTIVE TRK" + 'ENTER'

Select the number of the active track. The default setting is 1.

4.4.2 ENABLING TRACK STORING

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "TRACK" + 'ENTER' + "TRACK"

+ 'ENTER'

To enable (On) or disable (Off) the track storing. It is not possible to use the track

storing if you are not receiving a valid fix. The default setting is On.

4.4.3 DISPLAYING TRACK

'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "TRACK" + 'ENTER' + "VIS-

IBLE" + 'ENTER'

To enable (On) or disable (Off) the displaying of track. The default setting is On.