Operation Manual

76
User Manual
Note
An existing Event can be connected to the current route in another mode too. Place cursor on Event, the information
window related to the Event appears, press 'CLEAR' to close the window and then press 'ENTER', select the
Waypoint option and press 'ENTER'. The Event is connected to the current route.
4.3 MORE ABOUT A-B-C-D FUNCTION
The A-B-C-D function, explained in the previous paragraph 3.2, if Advanced Mode
is selected, allows you not only to create the A, B, C, D points and to delete them, but also
to modify and move them.
4.3.1 INSERTING THE A-B-C-D POINTS
Place the cursor on the desired position and press 'ENTER'. On the screen the
Create window appears, by using the cursor key select "A-B-C-D" and press 'ENTER': the
A point and an information window on A appear. Move the cursor, press 'ENTER', select
"A-B-C-D" and press 'ENTER' again: the B point appears, connected to A with a straight
segment; an information window on A-B segment (distance (DST), bearing (BRG) and
total distance from the first point) appears. Moving the cursor, pressing 'ENTER', selecting
"A-B-C-D" and pressing 'ENTER' places the C and D points (see previous Fig. 3.3.1).
4.3.2 DELETING THE A-B-C-D POINTS
When placing the cursor on the desired point (A, B, C or D) the information
window appears. Press 'ENTER', select "DELETE" and press 'ENTER' again: the point is
deleted. When the point is deleted, the cursor is placed on the previous point, if existed.
The labels of the next points are renamed.
4.3.3 DELETING THE A-B-C-D SEGMENT
When placing the cursor on the desired point (A, B, C or D) or on segment between
two points the information window appears. Press 'ENTER', select "DELETE ALL" and press
'ENTER' again: all points and connecting segments are deleted.
4.3.4 MOVING THE A-B-C-D POINTS
When placing the cursor on the desired point (A, B, C or D) the information window
appears. Press 'ENTER', select "MOVE" and press 'ENTER': by the cursor key move the
cursor, on the screen a dotted line connecting the point to move with the new position appears.
By pressing 'ENTER' the point is placing in the new position.