Operation Manual

71
User Manual
below) on a range set by the user for all route legs:
• Land Areas
• Shallow Water
• Intertidal Areas
• Rocks
• Wrecks
• Obstructions
• Shoreline Constructions
• Fishing Facility
• Dreged Areas
• Diffusers
• Mooring/Warping Facility
• Production Installation
• Pingos
• No Data Available
If any of these alarm conditions is detected, the function returns the list of
dangerous objects and the relative dangerous route leg, that is drawn with a different color.
It is possible to make the Safe Route Check from menu following the procedure:
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' +
"ROUTE CHECK REPORT" + 'ENTER'
or:
Place cursor on route leg + 'ENTER' + "ROUTE CHECK" + 'ENTER'
The list of the dangerous objects found on the charts crossed by the route is
shown in the route check report.
It is also possible to activate this function in automatic mode:
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' + "AU-
TOMATIC CHECK" + 'ENTER' + "ON" + 'ENTER'
If Automatic Route Check is activated, the modified Route legs are checked everytime
a Waypoint is added, inserted, edited or moved.
Before activating the function, you could change the function parameters, as the
width and the depth of the detected area and the research accuracy.
To select the width of the detected area aside the route:
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' +
"ROUTE WIDTH" + 'ENTER'
Note
Safe Route width value represents half the total width checked by the function.
To select the depth of the detected area aside the route:
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ROUTE" + 'ENTER' +
"ROUTE DEPTH" + 'ENTER'