Operation Manual

51
User Manual
Language: Allows setting the language to display chart information. The language is chosen
among the list of languages available on the cartographic data (C-CARD or embedded
charts).
'MENU' + "MAP SETTINGS" +'ENTER' + "Chart Language" + 'ENTER' + "Lan-
guage" + 'ENTER'
Mode: Defines how objects are translated. It is possible to choose between the three following
options:
• OFF : Uses the same Language used for LANGUAGE. If the selected
language is not present on the objects information, English is used
instead.
• ENGLISH : Always uses English.
• LOCAL : Uses the first Local language present on data. If no Local language
is available, English is used instead.
'MENU' + "MAP SETTINGS" +'ENTER' + "Chart Language" + 'ENTER' + "Mode"
+ 'ENTER'
Note
a. When User Interface Language is changed, Chart Language settings are set as follows: MODE is
set to Off and Chart Language is set as the User Interface Language selection if available on the chart
data, otherwise is set to English.
b. If the cartographic data is changed (for example the C-CARD is removed or replaced), Chart Language
settings should be verified and if necessary changed.
3.5.2 GETTING AUTOMATIC INFO
The type of Automatic Info is user selectable.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "SETUP" + 'ENTER' +"AUTO
INFO" + 'ENTER'
The possible settings are:
• Off: disabled, no automatic info shown at all.
• On Points: only on points. This is the default setting.
• On All: on all objects (points, lines and areas).
The Automatic Info On Points shows information when the cursor is placed on
points (as Port Services, Tides, lights, wrecks, rocks, buoys, beacons, obstructions, land
markers, etc.). The Automatic Info On All shows information when the cursor is placed on
points, on lines (as Depth contours, Traffic Separation, Territorial Sea, Cartographic Lines
etc.) on areas (Depth, Built-up, Sea, Attention, Restricted etc.) and on names (on the beginning
of the text -hot spot- or on any of the characters of the name -name message box-). The
details on Land, Source of Data, Cartographic Area and Spot Soundings are not shown.