Operation Manual

User Manual

3.2.8.6 C-Link

Selects the Master unit (Primary Station) or the Slave unit (Secondary Station):

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +

"C-LINK" + 'ENTER' + "Secondary Station/Primary Station" + 'ENTER'

3.2.8.7 External Signal

Sets the External Output. Then choose your preferred setting among External

Alarm (when activated, this pin goes to GND level. It is used to command an external

buzzer), External Power (it is command switch for the Radar. It must be used in conjunc-

tion with the Radar Junction box device) and Off.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +

"EXTERNAL SIGNAL" + 'ENTER'

3.2.8.8 Cable Wiring Pages

Shows a window containing the interface cable wiring. See Par. 6.3 and 6.4.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +

"POWER I/O CABLE WIRING" + 'ENTER'

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS

CABLE WIRING" + 'ENTER'

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "AUX

IN I/O CABLE WIRING" + 'ENTER'

3.2.9 C-VOICE MENU

AVAILABLE ONLY IF THE CHART PLOTTER IS CONNECTED TO VOICE NAVIGATION SYSTEM

The chart plotter has two different vocal modes, Navigation and Echosounder.

According to what mode is selected the messages spoken from the chart plotter are different.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER'

3.2.9.1 Navigation

Enables (On), disables (Off) or insert the time (2, 5, 10, 15 minutes) for the Navi-

gation Voice mode. If it is On, the message is always sent, as fast as possible. Instead if it is

one among the available values, for example 2 minutes, the message is sent related to the

selected time, in the previous example every two minutes.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "C-VOICE" + 'ENTER' +

"NAVIGATION" + 'ENTER'

3.2.9.2 Echosounder

Enables (On) or disables (Off) the Echosounder Voice mode. If it is On, the Depth

message is spoken. The message is spoken if a valid depth data is received by the chart

plotter or if it is in Simulation mode. The default setting is Off.