Operation Manual
38
User Manual
3.2.8.2 Port 1/Port 2/Port 3/Port 4/Port 5 Output
Sets or disables the output interface. The default setting is NMEA-0183 4800-N81-N.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 1/2/3/4/5 OUTPUT" + 'ENTER'
3.2.8.3 Port 1/Port 2/Port 3/Port 4/Port 5 NMEA Output
The chart plotter allows customizing the NMEA-0183 sentence transmitted on
each port. Each port can transmit a different set of sentences among: GLL, VTG, BOD,
XTE, BWC, RMA, RMB, RMC, APB, WCV, GGA, HSL, HDG. The default setting is GLL,
VTG, XTE, RMB, RMC, APB On and BOD, BWC, RMA, WCV, GGA, HSL , HDG Off.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 1/2/3/4/5 NMEA OUTPUT" + 'ENTER'
3.2.8.4 GPS Setup Menu
It is possible to set the your preferred configuration for the connected GPS.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS
SETUP" + 'ENTER'
Note
This item is shown alternately to the selection of the output messages when to the related port is connected a GPS
identificable by the chart plotter.
Restart GPS
Restars all GPS processes. Once executed, the message "Done" is shown.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS
SETUP" + 'ENTER' + "RESTART GPS" + 'ENTER'
Differential Correction Source
Allows setting what kind of Differential Correction will be used by the GPS between WAAS-
EGNOS and RTCM (beacon correction). The default setting is WAAS-EGNOS.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS
SETUP" + 'ENTER' + "DIFF CORRECTION SOURCE" + 'ENTER'
Navigation Speed
Allows setting the Navigation Speed among Low Speed, Medium Speed and High Speed.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS
SETUP" + 'ENTER' + "NAVIGATION SPEED" + 'ENTER'
3.2.8.5 Send & Receive Marks/Routes
Sets the desired port used for transferring User Points and Routes functions:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"SEND/REC ROUTES & MARKS" + 'ENTER' + "Port1/Port2" + 'ENTER'