Operation Manual

User Manual

Depth: Ft(Feet)/FM(Fathoms)/Mt(Meters). The default setting is Mt.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "DEPTH" + 'ENTER'

Altitude: Ft(Feet)/FL(Flight Level)/Mt(Meters). The default setting is Mt.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "ALTITUDE" + 'ENTER'

Temperature: °C/°F. The default setting is °C.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "TEMPERATURE" + 'ENTER'

3.2.7 NAV AIDS PRESENTATION

Allows to set the Nav Aids presentation as US or INTERNATIONAL. The de-

fault setting is INTERNATIONAL. When selected it affects Lights, Signals, Buoys & Bea-

cons display.

• International: Draws Nav-Aids using international symbology. All components of

Complex Objects are shown.

• US: Draw Nav-Aids using NOAA symbology. All components of Complex Ob-

jects are shown.

'MENU' + "BASIC SETTINGS" + 'ENTER' + "NAV AIDS PRESENTATION" +

'ENTER'

3.2.8 INPUT/OUTPUT MENU

WARNING !!!

After every software upgrade the RAM is cleared and the chart plotter re starts with the usual default settings. Please

go to the Input/output menu and set the proper input format once again.

3.2.8.1 Port 1/Port 2/Port 3/Port 4/Port 5 Input

Sets or disables the format for the navigation data input serial Port1/2/3/

4/5. The default setting is NMEA-0183 4800-N81-N. For example to set the Port 2 as

NMEA-0183 (4800 Baud Rate, Parity None, 8 Bits Number, 1 Stop Bit and Normal Polar-

ity) you must select:

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +

"PORT 1/2/3/4/5 INPUT" + 'ENTER'

Choose your preferred setting and press 'ENTER' to confirm.

Note (*)

The port selection for C-COM or BBFF (Fish Finder) system defines on which Port (in Input or Output) are to

be connected the two systems. It is important to remark that this setting affects the Input and the Output of the selected

Port. If the C-COM or BBFF (Fish Finder) was already assigned to one Port and the user tries to set the C-COM

or BBFF (Fish Finder) to another port, the chart plotter will show a message that warns the user about the current

settings and asks if the new settings should overwrite the previous ones.