Operation Manual

31
User Manual
3
For the New User
In order to get started using your chart plotter, you must do the following things:
1) Your chart plotter must have been installed properly according to the installation
instruction on Par. 6.2.
2) You must have performed the proper settings for use with your positioning
instrument (see Par. 2.5) and inserting the C-CARD for navigating in area you wish (see Par.
2.6).
3) You must have turned on the chart plotter and adjust the brightness and contrast
of the display (see Par. 2.2 and 2.3).
Once this is done, you can use your chart plotter for navigation.
3.1 SCREEN DISPLAY CONFIGURATION
Use 'PAGE' to select the desired page, in two different ways:
1) by showing the next page as the relative key is pressed
2) by selecting the page from the Page Selection menu
The desired way to select the page is set by changing "Page Preview" following the
procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "PAGE PREVIEW" + 'ENTER'
When "Page Preview" is "Off", 'PAGE' allows setting the next page (1). When
"Page Preview" is "On", 'PAGE' opens the Page Selection menu (2), on which the icons
representing the pages are shown: the icon of the currently selected page is identified by a
bold frame; move the selection with the Cursor keys or 'PAGE', the name of the currently
selected page icon is shown in the lower side of the Page Selection menu. Pressing 'EN-
TER' the Page Selection menu is closed and the currently selected page is activated.
Note
If in the Video Input menu the Select Video Input item is selected as Video 1, Video 2 or Auto Switch, it is possible