Operation Manual

25
User Manual
POWER & I/O
1
2
3
4
5
6
7
8
PIN CABLE COLOR FUNCTION
BLACK
RED
WHITE
GREEN
GRAY
YELLOW
BROWN
BLUE
PWR-/GND/COMMON
PWR+ (10-35 Vdc)
Used by C-COM
Used by C-COM
OUTPUT 2+
Used by C-COM
INPUT 2+
OUTPUT EXTERNAL ALARM+
POWER & I/O CONNECTOR/CABLE
Fig. 2.5.4 - C-COM Connection
Note
The connection is valid for the C-COM IR and C-COM RS232 too.
2. Into the Input/Output menu, set the C-COM for Port 1 as follows:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 1 INPUT" + 'ENTER' + "C-COM" + 'ENTER'
Also the modem C-COM can be connected to the other Ports, in this case set the
format for the selected Port.
2.5.5 EXTERNAL ALARM CONNECTION
To connect the External Alarm device see the following picture:
POWER & I/O
1
2
8
PIN CABLE COLOR FUNCTION
PWR
-/GND/COMMON
PWR +
(10-35 Vdc)
OUTPUT EXTERNAL ALARM+
(Open Collector)
BLACK
RED
BLUE
1
2
8
1
Current MAX 300mA
-
+
POWER SUPPLY
+
-
POWER & I/O CONNECTOR/CABLE
Fig. 2.5.5 - External Alarm Connection
Once the connection is active, to enable the External Alarm follow the procedure:
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' + "EX-
TERNAL ALARM" + 'ENTER' + "ON" + 'ENTER'
2.6 ADDITIONAL C-CARDS
The chart plotter uses two types of C-MAP B Y J EPPESEN cartridges: either a chart
cartridge or a data storage cartridge. A chart cartridge, called C-CARD, contains detailed
charts of the area covered. A data storage cartridge, called User C-CARD can be used to
permanently store your routes, Waypoints, Marks, Events and tracks.
Note
During normal operations the C-CARD should not be removed since the chart plotter may lock up.