Operation Manual

23
User Manual
2.5.2 AUTOPILOT CONNECTIONS
To connect the Autopilot to the serial Port 1 see the following picture:
POWER & I/O
POWER SUPPLY
1
POWER & I/O CABLE
POWER & I/O CABLE
PWR-/GND/COMMON
POWER INPUT+ (10-35 Vdc)
INPUT 1+
COMMON
OUTPUT 1+
BLACK
RED
WHITE
GREEN
YELLOW
PIN
1
2
3
4
6
WIRE COLOR
FUNCTION
-
+
AUTOPILOT
COMMON
RX+
Fig. 2.5.2 - Autopilot Connections on Port 1
To choose your preferred setting follow the procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 1 OUTPUT" + 'ENTER'
Then choose your preferred setting among the NMEA available settings NMEA-
0183 4800-N81-N, NMEA-0180, NMEA-0180/CDX (the default setting is NMEA-0183
4800-N81-N) and press 'ENTER' to confirm.
To connect the Autopilot to the serial Port 2 see the following picture:
POWER & I/O
POWER SUPPLY
-
+
1
POWER & I/O CABLE
POWER & I/O CABLE
PWR-/GND/COMMON
POWER INPUT+ (10-35 Vdc)
OUTPUT 2+
INPUT 2+
BLACK
RED
GRAY
BROWN
PIN
1
2
5
7
WIRE COLOR
FUNCTION
AUTOPILOT
COMMON
RX+
Fig. 2.5.2a - Autopilot Connections on Port 2
To choose your preferred setting follow the procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 2 OUTPUT" + 'ENTER'
Then choose your preferred setting among the NMEA available settings NMEA-
0183 4800-N81-N, NMEA-0180, NMEA-0180/CDX (the default setting is NMEA-0183
4800-N81-N) and press 'ENTER' to confirm.
2.5.3 EXTERNAL NMEA CONNECTIONS
To connect the External NMEA to the serial Port 1 see the following picture: