Operation Manual

User Manual

WARNING !!!

At very low temperatures the CCFL backlight may not glow properly. Allow a few minutes for it to warm up.

2.4 SELECTING THE USER INTERFACE LANGUAGE

It is possible to set the language to display menus, data pages, warning/alarm mes-

sages, full/quick info, list of objects found by find/nearest function, and on charts (such as

place's names, buoy's names and so on). The default setting is Italian.

To select the language you want:

'MENU' + "BASIC SETTINGS" + 'ENTER' + "LANGUAGE" + 'ENTER'

Choose the language you prefer and press 'ENTER' to confirm.

Note

If the selected language is not available on cartographic data, English language is used instead.

WARNING !!!

If you have accidentally selected an incomprehensible language, and you don't be able to reselect your language (the

above procedure is not of help to you), follow this procedure: press 'MENU', move the cursor to highlight the third

selection (starting from the top) which corresponds to the Basic Settings menu and press 'ENTER'. Then a window

appears with "Language" message, press 'ENTER'; now select your language and press 'ENTER' again.

Anyway if you in trouble, see Chapter "System Test" for a RAM Clear operation: the chart plotter will also return

all selections, in particular language, to original default values.

2.5 EXTERNAL CONNECTIONS

2.5.1 GPS CONNECTIONS

Connects the GPS to the GPS serial Port 3:

SMART GPS

SENSOR

GPS SENSOR CABLE

POWER OUTPUT+ (10-35 Vdc)

GPS RX+

GPS TX+

GND COMMON

RED

GREEN

BROWN

BLACK/YELLOW/SHIELD

GPS

ANTENNA

WIRE COLOR

FUNCTION

Fig. 2.5.1 - GPS Connection on Port 3

To choose your preferred setting follow the procedure:

'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +

"PORT 3 INPUT" + 'ENTER' + "NMEA-0183 4800-N81-N" + 'ENTER'

The GPS can be connected also to the Port 1 and 2, in this case select NMEA-

0183-4800-N81-N on the used port.