Operation Manual

100 User Manual
5.7.2 AIS MENU
To configure the chart plotter to receive AIS data, follow the procedure:
'MENU' + "AIS SETUP" + 'ENTER'
The AIS menu is shown on the screen, the items are described in the following
paragraphs.
5.7.2.1 Display
''MENU' + "AIS SETUP" + 'ENTER' + "DISPLAY" + 'ENTER'
Turns the display of AIS targets overlay on the cartography ON or OFF. The
default setting is ON.
5.7.2.2 Activation range
'MENU' + "AIS SETUP" + 'ENTER' + "ACTIVATION RANGE" + 'ENTER'
Defines the range from the fix within which the AIS Target becomes active. The
values allowed are from 0.1 to 20 Nm. The default setting is 5 Nm.
5.7.2.3 CPA Alarm
'MENU' + "AIS SETUP" + 'ENTER'+ "CPA ALARM" + 'ENTER'
Turns ON or OFF the alarm. The default setting is ON.
5.7.2.4 CPA Limit
'MENU' + "AIS SETUP" + 'ENTER' + "CPA LIMIT" + 'ENTER'
The values allowed are from 0.1 to 10 Nm. The default setting is 0.5 Nm.
5.7.2.5 TCPA Alarm
'MENU' + "AIS SETUP" + 'ENTER' + "TCPA ALARM" + 'ENTER'
Turns ON or OFF the alarm. The default setting is ON.
5.7.2.6 TCPA Limit
'MENU' + "AIS SETUP" + 'ENTER' + "TCPA LIMIT" + 'ENTER'
The values allowed are from 1 to 30 min. The default setting is 10 min.
5.7.3 TO SET THE CHART PLOTTER FOR RECEIVING AIS
Make sure that the AIS receiver is properly connected to the chart plotter.
The chart plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5.
Select the used serial port and transmission speed by following the procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT n INPUT" + 'ENTER' + "m" + 'ENTER'