Operation Manual

85
User Manual
condition if the navigation is activated on one of the two chart plotters, a warning message
will be shown to notify that the C-Link Navigation Data will be ignored by the other chart
plotter.
4.8.1.4 Slave Chart Plotter
Operating mode
To select the Slave mode (Secondary Station) follow the procedure:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"C-LINK" + 'ENTER' + "Secondary Station" + 'ENTER'
When Slave mode is set, the chart plotter cannot manipulate the C-Link Navigation Data
anymore.
Stop current navigation
If the navigation was already active, it will be disabled as soon as Slave mode is set. An
appropriate warning message will be shown to notify that the navigation is already active
and to confirm whether Slave mode can be set.
Inhibit navigation operation
As soon as Slave mode is set, the destination cannot be placed anymore either the C-Link
Navigation Data is received from the Master or not. Also, when the C-Link Navigation
Data is received from the Master, it will not be allowed to deactivate the navigation.
Inhibit Route following
While navigating to the Route received from the Master the destination is reached (either
applying distance or perpendicular criteria), the destination will not be moved to the next
Waypoint on the Route.
MOB handling
If the navigation to the external destination is active and 'MOB' is pressed on the Slave chart
plotter, the MOB is placed but the navigation to the MOB is not activated.
Notes
While navigating to the external destination the operating mode is switched to Master mode,
the navigation to the external destination will be terminated. An appropriate warning message
will be shown to notify that the navigation to the external destination is active and to confirm
whether Slave mode can be set. Setting Slave mode, the C-Link Navigation Data will be
deleted.