Operation Manual

38 User Manual
(4800 Baud Rate, Parity None, 8 Bits Number, 1 Stop Bit and Normal Polarity) you must
select:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 2 INPUT" + 'ENTER'+ "NMEA-0183 4800-N81-N" + 'ENTER'
Note
The option C-COM defines on which Port (both Input and Output) the C-COM modem is connected. It is important
to remark that this setting affects the Input and the Output of the selected Port. C-COM can only be set on one Port
at time. If C-COM was already assigned to a Port and the user tries to set the C-COM to another Port, the chart plotter
will show a message that warns the user about the current settings and asks if the new settings must overwrite the previous
ones.
3.2.8.2 Port 1/Port 2/Port 3 Output
Sets or disables the output interface. The default setting is NMEA-0183 4800-N81-
N. For example to set the Port 2 as NMEA-0180 you must select:
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 2 OUTPUT" + 'ENTER'+ "NMEA-0180" + 'ENTER'
Note
Selecting NMEA-0180 or NMEA-0180CDX the chart plotter shows a message to advise the user that the related
input will be disabled.
3.2.8.3 Port 1/Port 2/Port 3 NMEA Output Messages Selection
The chart plotter allows customizing the NMEA-0183 sentence transmitted on
each port. The default setting is GLL, VTG, XTE, RMB, RMC, APB On and BOD, BWC,
RMA, WCV, GGA, HSL , HDG Off.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' +
"PORT 1/2/3 OUTPUT SENTENCES" + 'ENTER'
3.2.8.4 GPS Setup Menu
It is possible to set the your preferred configuration for the connected GPS.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS
SETUP" + 'ENTER'
Note
This item is shown alternately to the selection of the output messages when to the related port is connected a GPS
identificable by the chart plotter.
Internal GPS For COMPACT X7
Enables (On) or disables (Off) the Internal GPS. The default setting is On.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS
SETUP" + 'ENTER' + "INTERNAL GPS" + 'ENTER'
Restart GPS
Restarts all GPS processes. Once executed, the message "Done" is shown.
'MENU' + "BASIC SETTINGS" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "GPS
SETUP" + 'ENTER' + "RESTART GPS" + 'ENTER'