Operation Manual

23
User Manual
The 'F UNCTION ' key
The 'F UNCTION ' key can be customized to have a quick access to some functions.
Pressing and holding down 'F UNCTION ' shows a pop-up window that contains all possible
functions assignable to the key. Move the cursor key up/down to place the selector on the
preferred item; move the cursor key to the right or press 'ENTER' to set the selected item;
move the cursor key to the left or press 'CLEAR' to close the pop-up window. The possible
choices are:
'W IND ' select Wind pages
'M ARK ' place Mark
'E VENT ' place Event
'W AYPOINT ' place Waypoint
'A-B-C-D' place A, B, C, D points
'EBL-VRM' place EBL and VRM
'C-W EATHER ' shows C-Weather Forecast mode
Press and release 'F UNCTION ' executes the function that was assigned.
Note
The selections Mark, Event, Waypoint and EBL.VRM are available even if Advanced Functions is Off.
2.2 TURNING THE CHART PLOTTER ON AND OFF
Before powering On the chart plotter, check for the correct voltage (10-35 volt dc,
see Par. 6.3) and the correct connections with the positioning instrument (see Par. 2.5).
2.2.1 TURNING ON
Press and hold the right side of 'POWER' for 1 second. The chart plotter emits
one rapid beep sound and a title page is opened. After a few seconds, the first of the two
Caution Notice pages is displayed, reminding you that the chart plotter is only an aid to
navigation, and should be used with appropriate prudence. The electronic charts are not
intended to substitute for the official charts. Then the cartographic screen is displayed.
2.2.2 TURNING OFF
Press the right side of 'POWER' and hold for 3 seconds: a countdown timer appears
on the screen, if you release the key before the countdown timer reaches zero, the chart
plotter will remain On.