Operation Manual

104
User Manual
Fig. 5.9.1 - AIS Symbols
5.7.2 AIS MENU
To configure the chart plotter to receive AIS data, follow the procedure:
'MENU' + "AIS SETUP" + 'ENTER'
The AIS menu is shown on the screen, the items are described in the fol-
lowing paragraphs.
5.7.2.1 Display
''MENU' + "AIS SETUP" + 'ENTER' + "DISPLAY" + 'ENTER'
Turns the display of AIS targets overlay on the cartography ON or OFF.
The default setting is ON.
5.7.2.2 Activation range
'MENU' + "AIS SETUP" + 'ENTER' + "ACTIVATION RANGE" + 'ENTER'
Defines the range from the fix within which the AIS Target becomes active.
The values allowed are from 0.1 to 20 Nm. The default setting is 5 Nm.
5.7.2.3 CPA Alarm
'MENU' + "AIS SETUP" + 'ENTER'+ "CPA ALARM" + 'ENTER'
Turns ON or OFF the alarm. The default setting is ON.
5.7.2.4 CPA Limit
'MENU' + "AIS SETUP" + 'ENTER' + "CPA LIMIT" + 'ENTER'
The values allowed are from 0.1 to 10 Nm. The default setting is 0.5 Nm.
5.7.2.5 TCPA Alarm
'MENU' + "AIS SETUP" + 'ENTER' + "TCPA ALARM" + 'ENTER'
Turns ON or OFF the alarm. The default setting is ON.
5.7.2.6 TCPA Limit
'MENU' + "AIS SETUP" + 'ENTER' + "TCPA LIMIT" + 'ENTER'
The values allowed are from 1 to 30 min. The default setting is 10 min.