Operation Manual

96
User Manual
the Grounding Alarm has been activated, a warning message is shown.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM" + 'ENTER'
Note
The Grounding Alarm function only operates with the new C-CARDs. It also affects the speed
of the redraw of the screen. If this function is not used it maybe disabled.
5.5.7 GROUNDING ALARM RANGE
Allows setting the length of the sector to be detected among 0.25, 0.5, 1.0 Nm.
The default setting is 0.25 Nm. When any of the searched objects is found in the scanned
area, a tick marker is printed on the relative box in the Grounding Alarm Report Page
(see Par. 5.5.7) to identify which dangerous objects have been currently detected.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM RANGE" + 'ENTER'
5.5.8 GROUNDING ALARM WIDTH
Allows setting the length of the sector to be detected among Thin, Medium
and Large. The default setting is Large.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM WIDTH" + 'ENTER'
5.5.9 GROUNDING ALARM REPORT
Allows displaying the report of the dangerous objects currently detected.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "ALARMS" + 'ENTER' +
"GROUNDING ALARM REPORT" + 'ENTER'
5.6 SIMULATION
The built-in Simulator function allows you to become proficient in the use
of the chart plotter. No current position fix is required because the chart plotter
simulates position data internally.
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "SIMULATION" + 'ENTER'
5.6.1 ACTIVATE SIMULATION
Once the settings are selected, turn on the Simulator:
'MENU' + "ADVANCED SETTINGS" + 'ENTER' + "SIMULATION" + 'ENTER' +
"ACTIVATE SIMULATION" + 'ENTER'
To turn On the Simulation select Off. The default setting is Off.