User's Manual

11
metal is present or no double D coil is connected.
This identication facility is tuned to the ground
with the automatic ground balance. There will be a
minimum speed of the coil necessary since this is a
motion function.
INTENSITY SIGNAL INTENSITY
BAR GRAPH ICONS
The signal strength will be indicated by the way of a
large bar graph in the middle of the LC Display and
an audio response from the speaker or headphones.
+/- GPS DIRECTION FINDER
AND DIFFERENTIAL INDICATOR
It is possible by means of the smaller bar graph with
center indication to nd the direction to walk each
track with data logger turned on and external Batte-
ry + GPS (Power Bank) module connected. It is also
possible to indicate under which part of a search
coil a metal piece is located when a dierential coil
is connected by the same +/- bargraph dot.
ARROW; AERIAL, USB ICONS
These icons will work together with the built-in data
logger function. Optional accessories like USB data
transfer cable, Battery + GPS module (Power Bank)
and Surfer Software will be also necessary when
collecting and displaying eld data. For further
information please refer to the instructions for use
the LORENZ DEEPMAX Z2 with data logger function
and software at chapter 14.
BATTERY ICON
The battery condition will be displayed on the bar
graph with 5 bars located on the top of the display.
Note: The battery condition should be checked with
a search coil connected and after a few minutes of
operation.
BATTERY ALARM LOW BAT
Low battery condition will be indicated by a pulsed
beep sound. The LORENZ DEEPMAX Z2 will turn OFF
automatically a short time after this sound appears
to avoid damage from the batteries.
Recommended settings for small coils (26 cm
to 44 cm diameter) Nuggets/ Coins/ Relics:
Nuggets/ High mineral:
GND3-5, FILTER 1, Auto 0-2, SENS 4-5, Volume 5,
DLOG 0, FREQ 5, AUDIO 2, LIGHT 8, TONE 3
Coin/ Relic single coil:
GND 2-5, FILTER 2, AUTO 0- 2, SENS 4-5, VOLUME 5,
DLOG 0, FREQ 5, AUDIO 2, LIGHT 8, TONE 2 or 3
Coin/ Relic double D coil
GND 2-5 (high mineral) or 6 (low mineral), FILTER 1,
AUTO 0- 2, SENS 4-5, VOLUME 5, DLOG 0, FREQ 5,
AUDIO 0, LIGHT 8, TONE 2 or 3
Recommended settings for large frame coils
(1m x 1m to 3m x 3m) Cache/ Relics/ Meteorites:
Low/ Medium mineral:
DEL 3 or 4, Filter 3, AUTO 0, SENS 4-5, VOLUME 5,
DLOG 0, FREQ 5, AUDIO 0, LIGHT 8, TONE 1, Keep
coil at constant height of 20-60cm over the ground.
High mineral:
GND 2-5, FILTER 3, AUTO 0, SENS 4-5, VOLUME 5,
DLOG 0, FREQ 5, AUDIO 0, LIGHT 8, TONE 1-3