User's Manual

3. Make the water-proof sliding cover well installed.

4. Connect PoE Injector to LP-2596K shown on diagram.

 DC: Plug in the DC jack of 24V/1A power adapter

 PoE port: Connect other end of Main Ethernet cable to PoE port.

 LAN port: Connect Ethernet cable from PoE injector to your computer/laptop for Web

configuration.

 Reset button: It allows user to remotely reset the system of LP-2596K.

Note.

1. There is no software driver or utility installation needed.

2. RJ-45 8P8C Ethernet cable is required.

3. It takes about 60 seconds to complete the boot up sequence after LP-2596K powered up.