User's Manual

46/61
 Enter the details of the credential and change configurations (SSID, Authentication,
Encryption and Key) manually if needed.
 Start PIN or PBC. The following procedures are as similar as section 2-7-3 (PIN
Enrollee Setup) or section 2-7-4(PBC Enrollee Setup),
 If your AP Enrollee has been configured before the WPS process, the credential
you set in advance will be updated to the AP itself. Otherwise, after a successful
registration, the AP Enrollee will be re-configured with the new parameters, and
the STA Registrar will connect to the AP Enrollee with these new parameters.
Describe "WPS Status Bar" - "PIN - xxx" as follow:
A successful PIN Configuration:
Start PIN connection - SSID ~> Begin associating to WPS AP ~> Associated to WPS
AP ~> Sending EAPOL-Start ~> Sending EAP-Rsp (ID) ~> Receive M1 ~> Sending
M2 ~> Receive M3 ~> Sending M4 ~> Receive M5 ~> Sending M6 ~> Receive M7
~> Sending M8 ~> Receive EAP Rsp (Done) ~> Sending EAP Rsp (ACK) ~>
Configured ~> WPS status is disconnected ~> WPS status is connected
successfully-SSID
Describe "WPS Status Bar" - “PBC - xxx" as follow:
A successful PBC Configuration:
Start PBC connection ~> Scanning AP ~> Begin associating to WPS AP ~>
Associated to WPS AP ~> Sending EAPOL-Start ~> Sending EAP-Rsp (ID) ~>
Receive M1 ~> Sending M2 ~> Receive M3 ~> Sending M4 ~> Receive M5 ~>
Sending M6 ~> Receive M7 ~> Sending M8 ~> Receive EAP Rsp (Done) ~>
Sending EAP Rsp (ACK) ~> Configured ~> WPS status is disconnected ~> WPS
status is connected successfully-SSID