User's Manual

Management Guide
-23-
PIN
Start to add to Registrar using PIN configuration method.
PBC
Start to add to AP using PBC configuration method.
WPS associate
IE
Send the association request with WPS IE during WPS setup. It is
optional for STA.
WPS probe IE
Send the probe request with WPS IE during WPS setup. It is
optional for STA.
Progress Bar
Display rate of progress from Start to Connected status.
Status Bar
Display currently WPS Status.
Note: When you click PIN or PBC, please don't do any rescan within two-minute
connection. If you want to abort this setup within the interval, restart PIN/PBC or
press Disconnect to stop WPS action.
5 Appendix
5.1 AP mode management guide
This adapter can be configured as AP mode. To function this adapter as an AP,
please right click the icon on system tray and select “Switch to AP mode”.
Please refer to the following introduction to information about this AP-mode utility.
Note: In Windows® XP, it provides WPA support at hotfix Q815485 However, you
have to make sure that hotfix Q815485 (require XP SP1 installed) has been installed
in your system before you can start using WPA features. You can check the
installation of hotfix in add/remove software page under control panel.