User's Manual

-22-
4.2.8 WPS
WPS Configuration: The primary goal of Wi-Fi Protected Setup (Wi-Fi Simple
Configuration) is to simplify the security setup and management of Wi-Fi networks.
This adapter supports the configuration setup using PIN configuration method or
PBC configuration method through an internal or external Registrar.
WPS AP List
Display the information of surrounding APs with WPS IE from last
scan result. List information include SSID, SSID, Channel, ID
(Device Password ID), Security-Enabled.
Rescan
Click to rescan the wireless networks.
Information
Display the information about WPS IE on the selected network. List
information include Authentication Type,
Encryption Type, Config Methods, Device Password ID, Selected
Registrar, State, Version, AP Setup Locked, UUID-E and RF
Bands.
PIN Code
8-digit numbers. It is required to enter PIN Code into Registrar
using PIN method. Each Network card has only one PIN Code of
Enrollee.
Config Mode
Enrollee or an external Registrar.
Table of
Credentials
Display all of credentials got from the Registrar. List information
includes SSID, MAC Address, Authentication
and Encryption Type. If STA Enrollee, credentials are created as
soon as each WPS success. If STA Registrar, RaUI creates a new
credential with WPA2-PSK/AES/64Hex-Key and doesn't change
until next switching to STA Registrar.
Detail
Information about Security and Key in the credential.
Connect
Command to connect to the selected network inside credentials.
Rotate
Command connect to the next network inside credentials.
Disconnect
Stop WPS action and disconnect this active link. And then select
the last profile at the Profile Page of RaUI if exist. If there is an
empty profile page, the driver will select any non-secue AP.
Delete
Delete an existing credential. And then select the next credential if
exist. If there is an empty credential, the driver will select any non-
security AP.