User's Manual
Table Of Contents
- 1. Terminology
- 2. Introduction
- 3. Installation
- 4. Software configuration
- 5. FREQUENTLY ASKED QUESTIONS (FAQ)
- 5.1 What and how to find my PC’s IP and MAC address?
- 5.2 What is Wireless LAN?
- 5.3 What are ISM bands?
- 5.4 How does wireless networking work?
- 5.5 What is BSSID?
- 5.6 What is ESSID?
- 5.7 What are potential factors that may causes interference?
- 5.8 What are the Open System and Shared Key authentications?
- 5.9 What is WEP?
- 5.10 What is Fragment Threshold?
- 5.11 What is RTS (Request to Send) Threshold?
- 5.12 What is Beacon Interval?
- 5.13 What is Preamble Type?
- 5.14 What is SSID Broadcast?
- 5.15 What is Wi-Fi Protected Access (WPA)?
- 5.16 What is WPA2?
- 5.17 What is 802.1x Authentication?
- 5.18 What is Temporal Key Integrity Protocol (TKIP)?
- 5.19 What is Advanced Encryption Standard (AES)?
- 5.20 What is Inter-Access Point Protocol (IAPP)?
- 5.21 What is Wireless Distribution System (WDS)?
- 5.22 What is Universal Plug and Play (uPNP)?
- 5.23 What is Maximum Transmission Unit (MTU) Size?
- 5.24 What is Clone MAC Address?
- 5.25 What is DDNS?
- 5.26 What is NTP Client?
- 5.27 What is VPN?
- 5.28 What is IPSEC?
- 5.29 What is WLAN Block Relay between Clients?
- 5.30 What is WMM?
- 5.31 What is WLAN ACK TIMEOUT?
- 5.32 What is Modulation Coding Scheme (MCS)?
- 5.33 What is Frame Aggregation?
- 5.34 What is Guard Intervals (GI)?
2.4G Outdoor Router
User Manual
2. Configure the LAN interface:
Open “Local Area Network (LAN) settings” page, enter the IP Address “10.10.10.254”, Subnet Mask
“255.255.255.0”. Enable DHCP Server, DHCP client range “10.10.10.100” to “10.10.10.200”, default
Gateway “10.10.10.254” .
Press “Apply” button to confirm the configuration setting.
3. Configure the WLAN interface:
Open “Basic Wireless Settings” page, enter the SSID ”AP”, Channel Number ”AutoSelect”.
Press “Apply” button to confirm the configuration setting.
- 55 -