User's Manual
Table Of Contents
- 1. Terminology
- 2. Introduction
- 3. Installation
- 4. Software configuration
- 5. FREQUENTLY ASKED QUESTIONS (FAQ)
- 5.1 What and how to find my PC’s IP and MAC address?
- 5.2 What is Wireless LAN?
- 5.3 What are ISM bands?
- 5.4 How does wireless networking work?
- 5.5 What is BSSID?
- 5.6 What is ESSID?
- 5.7 What are potential factors that may causes interference?
- 5.8 What are the Open System and Shared Key authentications?
- 5.9 What is WEP?
- 5.10 What is Fragment Threshold?
- 5.11 What is RTS (Request to Send) Threshold?
- 5.12 What is Beacon Interval?
- 5.13 What is Preamble Type?
- 5.14 What is SSID Broadcast?
- 5.15 What is Wi-Fi Protected Access (WPA)?
- 5.16 What is WPA2?
- 5.17 What is 802.1x Authentication?
- 5.18 What is Temporal Key Integrity Protocol (TKIP)?
- 5.19 What is Advanced Encryption Standard (AES)?
- 5.20 What is Inter-Access Point Protocol (IAPP)?
- 5.21 What is Wireless Distribution System (WDS)?
- 5.22 What is Universal Plug and Play (uPNP)?
- 5.23 What is Maximum Transmission Unit (MTU) Size?
- 5.24 What is Clone MAC Address?
- 5.25 What is DDNS?
- 5.26 What is NTP Client?
- 5.27 What is VPN?
- 5.28 What is IPSEC?
- 5.29 What is WLAN Block Relay between Clients?
- 5.30 What is WMM?
- 5.31 What is WLAN ACK TIMEOUT?
- 5.32 What is Modulation Coding Scheme (MCS)?
- 5.33 What is Frame Aggregation?
- 5.34 What is Guard Intervals (GI)?
2.4G Outdoor Router
User Manual
MBSSID AP
Isolation
Enable this function will turn off connection between clients with different
MBSSID. Example: The client connected with BSSID 1. When enable this
function, it will not connect with BSSID 2. Only can access between clients with
SSID 1.
BSSID Show the MAC address of Wireless interface.
Frequency (Channel) Select the wireless communication frequency/channel from pull-down menu.
Operating Mode Select “Mixed Mode” for 11b/g/n mode or “Green Field” for 11n mode.
Channel BandWidth
Select the operating channel width 20 MHz or 20/40 MHz.
Guard Interval Select “Long” or “Auto”. Guard intervals are used to ensure that distinct
transmissions do not interfere with one another. Only effect under Mixed Mode.
MCS Select 0~7 or “Auto” from pull down menu. The default is “Auto”. Only effect
under Mixed Mode.
4.3.4.2 Advanced
- 32 -