User's Manual
Table Of Contents
- 1. Terminology
- 2. Introduction
- 3. Installation
- 4. Software configuration
- 5. FREQUENTLY ASKED QUESTIONS (FAQ)
- 5.1 What and how to find my PC’s IP and MAC address?
- 5.2 What is Wireless LAN?
- 5.3 What are ISM bands?
- 5.4 How does wireless networking work?
- 5.5 What is BSSID?
- 5.6 What is ESSID?
- 5.7 What are potential factors that may causes interference?
- 5.8 What are the Open System and Shared Key authentications?
- 5.9 What is WEP?
- 5.10 What is Fragment Threshold?
- 5.11 What is RTS (Request to Send) Threshold?
- 5.12 What is Beacon Interval?
- 5.13 What is Preamble Type?
- 5.14 What is SSID Broadcast?
- 5.15 What is Wi-Fi Protected Access (WPA)?
- 5.16 What is WPA2?
- 5.17 What is 802.1x Authentication?
- 5.18 What is Temporal Key Integrity Protocol (TKIP)?
- 5.19 What is Advanced Encryption Standard (AES)?
- 5.20 What is Inter-Access Point Protocol (IAPP)?
- 5.21 What is Wireless Distribution System (WDS)?
- 5.22 What is Universal Plug and Play (uPNP)?
- 5.23 What is Maximum Transmission Unit (MTU) Size?
- 5.24 What is Clone MAC Address?
- 5.25 What is DDNS?
- 5.26 What is NTP Client?
- 5.27 What is VPN?
- 5.28 What is IPSEC?
- 5.29 What is WLAN Block Relay between Clients?
- 5.30 What is WMM?
- 5.31 What is WLAN ACK TIMEOUT?
- 5.32 What is Modulation Coding Scheme (MCS)?
- 5.33 What is Frame Aggregation?
- 5.34 What is Guard Intervals (GI)?
2.4G Outdoor Router
User Manual
4.3.3.2 LAN
Item Description
MAC Address
Show the MAC address of LAN interface.
IP Address
Fill in the IP address of LAN interfaces.
Subnet Mask
Fill in the subnet mask of LAN interfaces.
Default Gateway
Fill in the default gateway for LAN interfaces out going data packets.
DHCP Type Disable: Disable DHCP server on LAN side.
Server: Enable DHCP server on LAN side.
Start IP Address Fill in the start IP address to allocate a range of IP addresses; client with DHCP
function set will be assigned an IP address from the range.
End IP Address Fill in the end IP address to allocate a range of IP addresses; client with DHCP
function set will be assigned an IP address from the range.
Lease Time Fill in the lease time of DHCP server function.
802.1d Spanning
Tree
Select enable or disable the IEEE 802.1d Spanning Tree function from pull-down
menu.
LLTD Select enable or disable the Link Layer Topology Discover function from
pull-down menu.
IGMP Proxy Select enable or disable the IGMP proxy function from pull-down menu.
UPNP Select enable or disable the UPnP protocol from pull-down menu.
- 29 -