User's Manual
Table Of Contents
- 1. Terminology
- 2. Introduction
- 3. Installation
- 4. Software configuration
- 5. FREQUENTLY ASKED QUESTIONS (FAQ)
- 5.1 What and how to find my PC’s IP and MAC address?
- 5.2 What is Wireless LAN?
- 5.3 What are ISM bands?
- 5.4 How does wireless networking work?
- 5.5 What is BSSID?
- 5.6 What is ESSID?
- 5.7 What are potential factors that may causes interference?
- 5.8 What are the Open System and Shared Key authentications?
- 5.9 What is WEP?
- 5.10 What is Fragment Threshold?
- 5.11 What is RTS (Request to Send) Threshold?
- 5.12 What is Beacon Interval?
- 5.13 What is Preamble Type?
- 5.14 What is SSID Broadcast?
- 5.15 What is Wi-Fi Protected Access (WPA)?
- 5.16 What is WPA2?
- 5.17 What is 802.1x Authentication?
- 5.18 What is Temporal Key Integrity Protocol (TKIP)?
- 5.19 What is Advanced Encryption Standard (AES)?
- 5.20 What is Inter-Access Point Protocol (IAPP)?
- 5.21 What is Wireless Distribution System (WDS)?
- 5.22 What is Universal Plug and Play (uPNP)?
- 5.23 What is Maximum Transmission Unit (MTU) Size?
- 5.24 What is Clone MAC Address?
- 5.25 What is DDNS?
- 5.26 What is NTP Client?
- 5.27 What is VPN?
- 5.28 What is IPSEC?
- 5.29 What is WLAN Block Relay between Clients?
- 5.30 What is WMM?
- 5.31 What is WLAN ACK TIMEOUT?
- 5.32 What is Modulation Coding Scheme (MCS)?
- 5.33 What is Frame Aggregation?
- 5.34 What is Guard Intervals (GI)?
2.4G Outdoor Router
User Manual
d. L2TP
Item Description
Server IP Allow user to make a tunnel with remote site directly to secure the data
transmission among the connection. User can use embedded L2TP client
supported by this router to make a VPN connection.
If you select the L2TP support on WAN interface, fill in the IP address for it.
User Name Fill in the user name and password to login the L2TP server.
Password Fill in the user name and password to login the L2TP server.
Address Mode Static: To configure the IP address information by manually, please fill in the
related setting at below.
Dynamic: The option allows the machine to get IP address information
automatically from DHCP server on WAN side.
IP Address Fill in the IP address for WAN interface.
Subnet Mask Fill in the subnet mask for WAN interface.
Default Gateway Fill in the default gateway for WAN interface out going data packets.
Operation Mode
Keep Alive: Keep the L2TP connection all the time. Please also configure the
Redial Period field.
On Demand: Please configure the Idle Time field. When time is up, the L2TP
connection will disconnect. The connection will re-connect when any outgoing
packet arise.
Manual: Let user connect the L2TP connection manually.
MAC Clone Take NIC MAC address of PC on LAN side as the MAC address of WAN
interface.
- 27 -