User's Manual
Table Of Contents
- 1. Terminology
- 2. Introduction
- 3. Installation
- 4. Software configuration
- 5. FREQUENTLY ASKED QUESTIONS (FAQ)
- 5.1 What and how to find my PC’s IP and MAC address?
- 5.2 What is Wireless LAN?
- 5.3 What are ISM bands?
- 5.4 How does wireless networking work?
- 5.5 What is BSSID?
- 5.6 What is ESSID?
- 5.7 What are potential factors that may causes interference?
- 5.8 What are the Open System and Shared Key authentications?
- 5.9 What is WEP?
- 5.10 What is Fragment Threshold?
- 5.11 What is RTS (Request to Send) Threshold?
- 5.12 What is Beacon Interval?
- 5.13 What is Preamble Type?
- 5.14 What is SSID Broadcast?
- 5.15 What is Wi-Fi Protected Access (WPA)?
- 5.16 What is WPA2?
- 5.17 What is 802.1x Authentication?
- 5.18 What is Temporal Key Integrity Protocol (TKIP)?
- 5.19 What is Advanced Encryption Standard (AES)?
- 5.20 What is Inter-Access Point Protocol (IAPP)?
- 5.21 What is Wireless Distribution System (WDS)?
- 5.22 What is Universal Plug and Play (uPNP)?
- 5.23 What is Maximum Transmission Unit (MTU) Size?
- 5.24 What is Clone MAC Address?
- 5.25 What is DDNS?
- 5.26 What is NTP Client?
- 5.27 What is VPN?
- 5.28 What is IPSEC?
- 5.29 What is WLAN Block Relay between Clients?
- 5.30 What is WMM?
- 5.31 What is WLAN ACK TIMEOUT?
- 5.32 What is Modulation Coding Scheme (MCS)?
- 5.33 What is Frame Aggregation?
- 5.34 What is Guard Intervals (GI)?
2.4G Outdoor Router
User Manual
Step5: Complete the hardware installation as diagram at below.
3.2 Software Installation
There is no software driver or utility installation needed, but only the configuration
setting. Please refer to chapter 4 for software configuration.
Notice: It will take about 50 seconds to complete the boot up sequence after powered on the Outdoor
Router; Power LED will be active, and after that the WLAN Activity LED will be flashing to show the
WLAN interface is enabled and working now.
4. Software configuration
There are web based management and configuration functions allowing you to have the jobs done
easily.
The Outdoor Router is delivered with the following factory default parameters on the Ethernet LAN
interfaces.
Default IP Address: 192.168.1.254
Default IP subnet mask: 255.255.255.0
WEB login User Name: admin
WEB login Password: admin
- 14 -