User's Manual

Example to Reconnect 802.1x Authenticated Connection after
802.1x Authenticated connection Is Failed in Profile
There are two situations to be able to reconnect 802.1x authenticated connection and authenticate
successfully after 802.1x authenticated connection is failed in profile page. Two examples about this
case are as follows:
When keying in error identity, password or domain name :
Authentication type chooses "PEAP", key identity into test. Tunnel Protocol is "EAP- MSCHAP-
v2, and tunnel identity is test and tunnel password is test. Those setting are same as our intended
AP's setting.
Because keying error identity and error password, the result will look like the below figure.
If you want to disconnect, click cancel button in Authentication Failure dialog. If you want
to reconnect, key identity into wpatest2. And tunnel identity is wpatest2 and tunnel
password is test2. Those setting are same as our intended AP's setting.
- 82 -