User's Manual

Start RaUI
When starting RaUI, system will connect to the AP with best signal strength without setting
profile or matching profile setting. When starting RaUI, it will issue a scan command to
wireless NIC. After two seconds, the AP list will updated with the result of BSS list scan. The
AP list include most used fields, such as SSID, network type, channel used, wireless mode,
security status and signal percentage. The arrow icon indicates the connected BSS
or IBSS network. The page is shown as Figure 2-1.
Figure 2-1-1 RaUI section introduction
There are three sections in RaUI. These sections are briefly described as follow.
- 19 -