Manualshelf

Certifications

ManualsBrandsLoon Peak ManualsAll Outdoor Fireplaces & Fire PitsFelan 18" H x 48" W Concrete Propane Outdoor Fire Pit Table
12345678910
Page No: 2
Date Issued: December 12, 2016
DQD 507.10 Rev 2016-07-15
MARKINGS
The manufacturer is required to apply the following markings:
Products shall be marked with the markings specified by the particular product standard.
Products certified for Canada shall have all Caution and Warning markings in both English and French.
Additional bilingual markings not covered by the product standard(s) may be required by the Authorities Having
Jurisdiction. It is the responsibility of the manufacturer to provide and apply these additional markings, where
applicable, in accordance with the requirements of those authorities.
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US (indicating that products have been manufactured to the requirements of both Canadian and U.S. Standards) or
with adjacent indicator 'US' for US only or without either indicator for Canada only.
Nameplate adhesive label material approval information:
All markings in compliance with the applicable requirements are found on descriptive drawing Figure 152. The
specifications of the marking system as follows: Nameplate are permanent tags made of Aluminum sheet with silk
screen printing ink with the maximum temperature 120C. The lighting instruction and warnings are silk screen
with the maximum temperature 120C.
ALTERATIONS
70100510
- Fixed one of the nuts of thermocouple of model S4-001, S5-001, S5-003, S5-005, S5-006 and S5-007, to
comply with section 4.1.1. See Figure 10, 34, 81, 106, 130 for detail.
- Added Dia.20mm gasket on the end of cylinder fixing screw of all models, to comply with section 4.11.1. See
Figure 68, 88, 137 for detail.
- For S5-001, increased the distance between the floor of cylinder enclosure and ground to 2in, to comply with
section 4.12.4. See Figure 26 for detail.
- For model S5-001, added iron bars at the floor of cylinder enclosure, to avoid a spare cylinder is put into by
mistake, and to comply with section 1.8. See Figure 47 for detail.
- IMs modified.
- Markings modified.