Installation & Assembly

Lamp Body(A)
Socket section (B)
Bulb (C)
Harp (D)
Shade (E)
Finial (G)
Plastic Washer(F)
ASSEMBLY INSTRUCTIONS:
1. CAREFULLY UNPACK AND PLACE ALL PARTS ON A FLAT
SURFACE AND LINE THEM UP AS PER THE SKETCH.
2. SCREW SOCKET SECTION (B) INTO LAMP BODY (A), AND PULL
WIRE OUT.
3. INSERT HARP (D) INTO SADDLE OF SOCKET SECTION (B).
4. SCREW BULB (C) INTO SOCKET OF SOCKET SECTION (B).
5. INSTALL SHADE (E), PLASTIC WASHER (F) ONTO HARP (D), THEN
SECURE WITH FINIAL (G) AND ADJUST THE BALANCE OF
SHADE.
6. INSERT THE POLARIZED PLUG INTO WALL OUTLET, TURN ON
THE SWITCH AND ENJOY YOUR NEW LAMP.
IMPORTANT SAFETY INSTRUCTIONS:
ATTENTION
USE A LT-25W 3WAY CFL TYPE BULB OR 150W 3WAY (MAXIMUM) INCANDESCENT A TYPE BULB.
POUR PRÉVENIR LES CHOCS ÉLECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE AVEC UN
PROLONGATEUR, UNE PRISE DE COURANT OU UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES
PEUVENT ÊTRE INSÉRÉES A FOND SANS EN LAISSER AUCUNE PARTIE À DÉCOUVERT
※ PLEASE INFORM YOUR DEALER IMMEDIATELY IN CASE OF ANY PARTS SHORTAGE.
※ SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A
SAFETY FEATURE TO REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A
POLARIZED OUTLET ONLY ONE WAY. IF IT DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE
PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. NEVER USE WITH AN
EXTENSION CORD UNLESS THE PLUG CAN BE FULLY AND EASILY INSERTED. DO NOT ATTEMPT TO
ALTER THE PLUG.