Installation & Assembly

PLEASE READ THE ASSEMBLY INSTRUCTION SHEET CAREFULLY BEFORE PROCEEDING. Carefully unpack

and identify all parts prior to building the unit. Each part is identied on the drawing for reference.

DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection, you must return the item for any

reason. Please repack the unit using the original carton and inserts.

STEP 1: Unpack all the parts and classify them

according to the illustration shown at the side.

Place the parts on a scratch free surface.

STEP 2: Install the glass panels into the frame

and x it using the clips.

STEP 3: lnstall the loop to the xture.

STEP 4: lnstall the correct bulb (provided).

STEP 5: Buckle the chain to the xture and loop.

STEP 6: Make sure the power is turned off at

the ceiling junction box where the xture is to be

installed. Secure the mounting bracket to the

junction box using the outlet box screws.

STEP 7: Use the wire connector to connect the

positive and negative wires. Connect the ground

wire to the junction box ground port.

STEP 8: Secure the canopy to the ceiling

junction box using the knurled ring.

Turn on the power at fuse or circuit box.

ASSEMBLY AND MOUNTING INSTRUCTIONS

CAUTION:

To reduce the risk of re, use the specied lamp wattage (or smaller) and bulb type identied on the product.

CLEANING INSTRUCTIONS:

Do not use polish or cleaners on your product. Just wipe clean with a soft cloth.

CAUTION – RISK OF FIRE

This product requires installation by a qualied electrician. Before installing be sure to read all instructions

and TURN THE POWER TO THE ELECTRICAL JUNCTION BOX OFF.

PAGE 1
ASSEMBLY AND MOUNTING INSTRUCTIONS PLEASE READ THE ASSEMBLY INSTRUCTION SHEET CAREFULLY BEFORE PROCEEDING. Carefully unpack and identify all parts prior to building the unit. Each part is identified on the drawing for reference. DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection, you must return the item for any reason. Please repack the unit using the original carton and inserts. STEP 1: Unpack all the parts and classify them according to the illustration shown at the side.
PAGE 2
ESPAÑOL: INSTRUCCIONES DE ENSAMBLAJE Y MONTAJE ANTES DE CONTINUAR, LEA DETENIDAMENTE LA HOJA DE INSTRUCCIONES DE ENSAMBLAJE. Desempaque con cuidado e identifique todas las piezas antes de armar la unidad. Cada pieza está identificada en el dibujo de referencia. NO DESECHE EL EMBALAJE ORIGINAL. Si después de una inspección exhaustiva tiene que devolver el artículo por algún motivo, vuelva a embalar la unidad con la caja original y los elementos internos de la caja.