Installation Instructions

1
Installation Instructions for
1
2
3
4
5
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
Outdoor
1A
JUNCTION BOX
MOUNTING
PLATE
3
4
FIXTURE
SCREW
6
7
8
8
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for wet locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
5
LAMP
DIFFUSER
COVER
COVER SCREW
FIXTURE
6
7
Outdoor Wall
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
Insert the diffuser into the fixture and secure it in place by installing the cover using the cover screws.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.